Overview

The VerteX is designed to give the ultimate in lighting control from a typical speedlight by allowing almost an infinite amount of adjustment. The VerteX is a mechanical device that can accept one or two panels on it to allow you to send the light in the specific direction(s) that you want.

The VerteX works by having a swinging arm that can have either one or two flaps attached to it that can rotate 360 degrees. Each flap has a mirrored side and a white diffusion side.  By adjusting the swing arm and the flaps you can split the light coming out of your accessory flash and send the light in different directions. Nothing else on the market today gives you this much control over your lighting.

Setup

Normally I would go into a real lengthy section and maybe even some step-by-step pics showing how to assemble a product. Bust seriously, the VerteX takes about 30 seconds to setup, you will spend more time reading this paragraph than you will spend setting the VerteX up. You take the two arms and snap them into place in the holes on the sides of the rubber band, push them together over the cross piece, and push the flaps into place, which are held there with magnets. That’s it. I find it easier to get onto the flash if you attach the rubber band to the flash head right after putting the two arms on and before attaching the cross bean and flaps. In under a minute you are ready to start taking pictures with the VerteX.

Usage

I am going to be really honest here, if you really don’t understand lighting, you may have trouble previsualizing what you can achieve with the VerteX. However, if you are the type of person who can look at a scene and know, for example,  that you want a slight shadow from one direction, a little fill up front, and some top lighting, then you will be able to use the VerteX to it’s full potential. Since you can split the light and send some forward, some up to bounce off the ceiling, some left to bounce off a wall, you can achieve lighting effects that otherwise would have required multiple strobes.

Results

Before getting into wedding photography I did mostly product photography so using multiple lights was second nature, getting into wedding photography felt very limiting as it really isn’t practical on most shoots to lug around multiple light sources, radio remotes, light stands, etc and the current light modifiers on the market work very well in specific situations, but there hasn’t been a product that could really give you the flexibility of multiple light sources from a single strobe head until the VerteX. Here are a few shots from a recent wedding where I used the VerteX to get some really nicely lit indoor shots.

Summary

While the VerteX may look like a homing beacon for an alien spacecraft, it does exactly what it is intended to do. I am thrilled with the control over the light that it gives me and enables lighting that simply wasn’t possible before.  For $49.95, it isn’t any more than other brand-name modifiers but it does give you a level of control that other products do not. I have used the VerteX at several weddings now and it has not come off my flash yet. The only real negative thing I can say is that if you happen to bump something and one of the flaps comes off, they are so light that you stand a good chance of not noticing since you usually wont hear it hit the ground. Most of the time I use it as pictured in the image to the right with only one flap, so if I actually lost one for good, I could get by for a while, so keep an eye on the panels wqhen you are moving your equipment around.

Here is a little video showing more about the VerteX and how I use it.

VerteX Light Modifer from Presslite from Kerry Garrison on Vimeo.

Product Review Scorecard

Product Page: http://www.presslite.com/vertexinfo.php
Company Page: http://www.presslite.com

Author: Kerry Garrison

Photoshop CS4 Fluid Zoom and View Rotation from Kerry Garrison on Vimeo.